Fabrication of Three-Dimensional Porous Scaffolds with Complicated Shape for Tissue Engineering. I. Compression Molding Based on Flexible-Rigid Combined Mould.
作者：Wu Linbo, Zhang Hong, Zhang Junchuan, Ding Jiandong*
关键字：Three-dimensional porous scaffolds ， A porous scaffold ，Viability of cells
论文来源：期刊
具体来源：Tissue Engineering. 11(7-8):1105-1114, 2005.7
发表时间：2005年
A novel method for the fabrication of complexly shaped three-dimensional porous scaffolds has been developed by combining modified compression molding and conventional particulate leaching. The resultant scaffolds of various shapes, including some shaped like auricles, were made of hydrophobic
biodegradable and bioresorbable poly(D,L-lactic acid) (PDLLA) and poly(D,L-lactic-co-glycolic acid) (PLGA). A polymer–particulate mixture was first prepared by the conventional solvent casting method and then compressively molded in a specially designed flexible–rigid combined mold which facilitates shaping and mold release during the fabrication process. The molding was carried out at a moderate temperature, above the glass transition temperature and below the flow temperature of these amorphous polymers. A porous scaffold was then obtained after particulate leaching. The pores are highly interconnected and uniformly distributed both in the bulk and on the external surface of the scaffolds, and the porosity can exceed 90%. The mechanical properties of the resultant porous scaffolds are satisfactory as determined by measurements of compressive modulus and compressive stress at 10% strain. Good viability of cells seeded in the porous scaffolds was confirmed. This novel fabrication method is promising in tissue engineering because of its ability to produce precise and complexly (anatomically) shaped porous scaffolds.